White Leather Trainers

How to Clean Leather Shoes with Bicarbonate of Soda

Can bicarbonate of soda clean white leather trainers? How to use a gentle paste, where it helps, where to avoid it, and a note on Birkenstocks.

On this page
  1. Is bicarbonate of soda safe on leather?
  2. What bicarb is good for (and what it isn’t)
  3. How to use a bicarb paste on white leather trainers
  4. Using bicarb to deodorise shoes
  5. Cleaning Birkenstocks with bicarb
  6. Mistakes to avoid
  7. Aftercare

Bicarbonate of soda (baking soda) can be used on white leather trainers, but gently and sparingly. It is a mild abrasive, so it is better suited to rubber soles, odour and the odd stubborn mark than to regular cleaning of the leather itself. On the leather, use a small amount, keep scrubbing light, and test on a hidden spot first.

Is bicarbonate of soda safe on leather?

Often it is fine for occasional use, but it isn’t risk-free. Bicarb is slightly abrasive and can dull or dry out coated or delicate leather if you scrub hard or use it often. Mixed with too much water it can also leave a chalky film. Shoe-care guides generally suggest a light touch, a test patch, and conditioning afterwards.

If your shoes have a very smooth, glossy or coated finish, a mild soap solution or a dedicated leather cleaner is usually the gentler first choice. Our main guide to cleaning white leather trainers sets out that routine.

What bicarb is good for (and what it isn’t)

Good for

Less good for

  • Regular cleaning of the leather upper
  • Yellowing, which is usually a finish or rubber oxidation issue (see whitening yellowed soles)
  • Deep stains, where repeated scrubbing could harm the surface

How to use a bicarb paste on white leather trainers

  1. Remove the laces and brush off loose dirt with a dry, soft brush.
  2. Mix about one to two tablespoons of bicarbonate of soda with just enough water to make a thick paste.
  3. Test it on a hidden area, such as the inside of the tongue, and let it dry.
  4. If it looks fine, dab a small amount onto the mark with a soft toothbrush or cloth and work it in light circles.
  5. Leave it for around five to ten minutes at most.
  6. Wipe it away completely with a clean, damp cloth, so no white residue is left.
  7. Let the shoes air dry at room temperature, away from heat and direct sun.
  8. Once dry, apply a small amount of leather conditioner if the leather feels dry.

Don’t soak the shoe. If it hasn’t improved after one or two attempts, stop and switch to a leather-safe cleaner.

Using bicarb to deodorise shoes

For smell rather than dirt, sprinkle dry bicarb inside each shoe or on removable insoles, leave it for several hours or overnight, then tip it out and brush or vacuum away what’s left. It is a low-risk way to freshen shoes, and it keeps water away from the leather. For stubborn odour, see how to clean smelly boots.

Cleaning Birkenstocks with bicarb

Birkenstock footbeds typically have a cork core and a suede or leather-style lining, so too much water can cause problems. Some guides suggest a thick paste of about two parts bicarb to one part water, applied with a soft brush, wiped off with a barely damp cloth, and dried slowly for a day or so away from heat. Others, including some reviewers, caution that scrubbing with bicarb and extra water can stiffen the lining or harm the cork, so use as little water as possible and test first. For the uppers, check whether yours are suede, oiled leather or a synthetic, because each needs a different approach. Suede uppers are covered in our guide to cleaning suede shoes.

Mistakes to avoid

  • Mixing bicarb with vinegar. The two largely neutralise each other, and some guides recommend against it on leather. If you want vinegar for something else, use it separately and diluted, and test first.
  • Adding dish soap to the paste. Reports from wearers suggest this can leave leather looking worse.
  • Using baking powder as a substitute. It contains other ingredients, so stick to plain bicarbonate of soda.
  • Scrubbing hard. The aim is to lift, not sand.
  • Skipping conditioner on leather that now feels dry.

Aftercare

Once the shoes are fully dry, a light application of leather conditioner on a soft cloth helps restore suppleness. Buff off any excess. For wider tips on stopping the dirt returning, see our guide on getting white leather white again.

The complete guide to white leather trainers

How to Clean White Leather Trainers (and Get Them White Again)
Read the guide

Keep exploring

Guides from other topics

All topics →